For Manufacturers
Offcuts, rejected castings, and trim aren't a one-off clean-out, they're generated every production run. Clean, sorted, high-grade material like this is worth more than most manufacturers realise.
Unlike demolition or end-of-life scrap, which usually arrives mixed and contaminated, production offcuts are typically already sorted by alloy and free of paint, coatings, and attached non-metal material. Clean bare bright copper wire, uncoated aluminium extrusion, and single-grade stainless offcuts are among the highest-value, most consistently priced categories in the whole scrap market, precisely because a buyer doesn't need to sort or clean them further.
Clean, uncontaminated pieces cut away during machining.
Parts that don't pass QC, still full-value scrap even if they're not sellable product.
Edge trim and punch-outs from sheet forming.
End-of-life dies, jigs, and fixtures once they're no longer usable in production.
There's no minimum volume to list, so it scales with whatever a production run actually generates, weekly, monthly, or tied to a specific job. Check today's reference prices each time rather than assuming last month's rate still holds.
Every listing reaches verified buyers, and payment is held in escrow until pickup or delivery is confirmed, the same protection whether it's a single offcut load or a standing arrangement. See how negotiation works if you'd rather propose a price directly than run each load as an auction.
It's usually already sorted by alloy and free of the coatings, paint, and contamination that mixed demolition or consumer scrap carries. Clean, single-grade offcuts like bare bright copper wire or uncoated aluminium extrusion consistently price higher than the same metals recovered from a mixed load.
For most manufacturing operations, yes. Production scrap is generated continuously, not as a one-off event, so treating it as a recurring listing rather than an occasional clean-out means you're capturing value as it's generated instead of letting it sit and take up space.
Sorted, single-grade material prices better. If your process already separates by material, which most CNC and fabrication workflows do to some extent, listing by grade rather than as one mixed lot is worth the extra step.
You can list as frequently as material accumulates, whether that's weekly, monthly, or tied to a specific job. There's no minimum volume requirement to list, so it scales with however much you're actually generating.
Check the reference price each time before you list or accept an offer, rather than assuming last month's rate still applies. Scrap prices move with the same market factors as any commodity, so treating it as a fixed number is the most common way to leave money on the table.
Turn recurring offcuts into a predictable revenue line.
Get Started Free